1995-2002 Genuine Original
Factory Fit OEM Mercedes-Benz S-Class W140 C140 S280 S300
S320 S400 S420 S430 S500 S600 S55 AMG Also Called : 300SE/SEL,
400/500/600SEL, 500/600SEC, 300SD Headlights Headlamp HID
D2R Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/Inverter ) , D2R Philips Xenon Bulb , 2Pin Ignition Replacement
Change
Part will fit : Driver side / Passenger
side / Left / Light / Front (Third generation)
Mercedes-Benz S
Class : 4-door sedan (W140; short) , 4-door sedan (V140;
long) , 4-door sedan (VV140; Pullman) , 2-door coupé (C140)
Petrol:
2.8 – 3.2 L M104 I6
4.2 – 5.0 L M119 V8
6.0 L M120 V12
7.1 – 7.3 L M120 AMG V12
Diesel:
3.0 L OM606 turbo I6
3.5 L OM603 turbo I6
A1408200659 , A1408209461 , A1408209361
, A1408209261 , A1408260643 , 1305235302 , 1305235301 ,
0302470272 , A1408200549 , 0302454012 , A1408202561 , A1408203061
, 1305544152 , A1408206661 , A1408261677 , A1408207861 ,
A1408261677 , A1408261880 , A1408207661 , 1305235243 , 1305621636
, A1408207861 , A1408202561
If your 1995-2002 Mercedes-Benz S-Class
W140 S320 S280 S400 S300 S420 S430 S500 S600 S55 AMG OEM
HID Xenon Headlight low beam or Headlamp projector housing
high beam have problems, like light failed failure, flicker
, bad , dipped beam very dim dimmer, dimming , got wet ,
getting dimmer, not working, flickering blinking , goes
one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|