2008-2012 Genuine Original
Factory Fit OEM Mercedes-Benz GLK Class X204 GLK200 GLK220
GLK250 GLK280 GLK300 GLK320 GLK350 Headlights LHD RHD Headlamp
HID D1S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/Inverter ) , D1S Philips Xenon Bulb ,Ignition , Lamp Retaining
ring , Wires Cable Harness , Bulb Holder Ring , Projector
Reflektor Bowls , Plastic Lens Cover , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
2008-2012 Mercedes-Benz
GLK-Class X204 : 5-door SUV
3.0L V6
3.5L V6
2.1L CDI I4
3.0L CDI V6
If your 2008-2012 Mercedes-Benz GLK Class
X204 GLK200 GLK220 GLK250 GLK280 GLK300 GLK320 GLK350 HID
Bi-Xenon Adaptive AFS Headlight low beam or Headlamp projector
housing high beam have problems, like light failed failure,
flicker , bad , dipped beam very dim dimmer, dimming , got
wet , getting dimmer, not working, flickering blinking ,
goes one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|