
2003-2013 Genuine Original Factory Fit OEM Mitsubishi Lancer
Evolution VIII IX X Evo8 Evo9 Evo10 Headlights Headlamp
HID D2S D2R Ballast (Xenon Light Control Unit / Module /
Controller / ECU / Computer / Starter / Electronic Unit
/ Steuergerät / Inverter ) , D2S Philips Xenon Bulb ,Ignition
, Lamp Retaining ring , Wires Cable Harness , Bulb Holder
Ring , Projector Reflektor Bowls, Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (Eighth Ninth Tenth Generation)
2003-2006 Mitsubishi
Evolution 8 9 (CT9A): 4-door sedan , 5-door wagon (Evo IX,
2007) , RS , MR RS , GT , GSR , MR GSR , MR Tuned by RALLIART
, FQ-300, 320, 340 , FQ-360 , MR FQ-360
2007-2013 Mitsubishi
Lancer Evo10 (CZ4A): 4-door sedan , RS , GSR , GSR-Premium
, GSR Tuned by RALLIART , MR Touring , SE , GSR SST , MR
TC-SS , Bathurst Edition
If your 2003-2013 Mitsubishi Lancer Evolution VIII IX X
Evo8 Evo9 Evo10 HID Xenon headlight have problems like:
light failed failure, very dim dimmer, dipped , waring light
, dipped beam, keeps going out , not working, flickering
, error , fault , goes on and off out , go up and down ,
moving up and donw , pointing down , distance control defective
, malfuncation ,turning pink , not turning off , gone ping
, turned purple ,turned pink , not bright enoug h , flashing
. warning light ,not working properly , keeps burning out
, or have any other issues, you only need to change or replacement
original xenon parts like: ballast, gas discharge bulb,
igniter or wire harness, cable to repair your HID headlamp
is ok, no need to cost a lot of money to buy high price
a whole brand new headlight assembly like the car dealer
suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|