2001-2007 Genuine Original Factory Fit OEM Mitsubishi Lancer Evolution Ev07 Evo8 Evo9 JDM VII VIII IX Also Called : Mitsubishi Cedia
Mitsubishi Lancer Cedia (Japan & Thailand)
Mitsubishi Virage (Taiwan)
Soueast Lioncel II
Mitsubishi Lancer Gala (Vietnam)
Mitsubishi Lancer GLX-I (Venezuela) Headlights LHD RHD Headlamp HID D2S D2R Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , D2S Philips Xenon Bulb ,Ignition , Lamp Retaining ring , Wires Cable Harness , Bulb Holder Ring , Projector Reflektor Bowls, Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Seventh Eighth Ninth Generation)

Mitsubishi Evolution 7 8 9 (CT9A , CT9W ): 4-door sedan , 5-door wagon (Evo IX, 2007)

Gasoline:
1.3 L 4G13 I4
1.5 L 4G15 I4
1.6 L 4G18 I4
1.8 L 4G93 I4
1.8 L 4G93T turbo I4
2.0 L 4G94 I4
2.0 L 4G63 I4
2.4 L 4G69 I4

2.0 L 4G63 Inline 4 Turbocharged , Evolution VII GT-A , 2.0 L (1,997 cc) 4G63 Inline-four engine Turbocharged ,

RS , MR RS , GT , GSR , MR GSR , MR Tuned by RALLIART , SE , FQ-300, 320, 340 , FQ-360 , MR FQ-360

If your 2001-2007 Mitsubishi Lancer Evolution VIII IX X Evo7 Evo8 Evo9 OEM HID Xenon Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your xenon led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.