2008-2017 Genuine Original Factory Fit OEM Mitsubishi Lancer Gen9 Mk9 Evo10 Also Called : Mitsubishi Galant Fortis (Japan) , Mitsubishi Galant , Proton Inspira (Malaysia) , Mitsubishi Lancer EX Headlights LHD RHD Headlamp HID D2S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , D2S Philips Xenon Gas Bulb Globes , Headlight Plastic Lens Cover Housing , Projector Reflector Blow , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Ninth Generation)

Mitsubishi Lancer : 4-door sedan (GS41) , 5-door hatchback (GS44S)

Gasoline:
1.5 L 4A91 I4
1.6 L 4A92 I4
1.8 L 4B10 I4
1.8 L 4J10 I4
2.0 L 4B11 I4
2.0 L 4B11T turbo I4
2.4 L 4B12 I4
Diesel:
1.8 L 4N13 turbo I4
2.0 L VW BWC turbo I4
EVO10 X CZ4A : 1998 cc 4B11T turbocharged I4 (RS , GSR Tuned by RALLIART , MR , SE , MR Touring , Final Edition , SST , FQ300 330 360 400 , Carbon Series, 2015 John Easton Edition , SST)

If your 2008-2017 Mitsubishi Lancer Evo8 Evo10 XOEM HID Xenon Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your xenon led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.