
2008-2013 Genuine Original Factory Fit OEM Mitsubishi Toppo
Also Called: Mitsubishi Minica Toppo , Mitsubishi Minica
Toppo Town Bee , Mitsubishi Toppo BJ Headlights Headlamp
HID D2S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) , D2S Philips Xenon Gas Bulb , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (Second Generation)
Mitsubishi Toppo
: Kei car , 3G83 657 cc I3 , 4A30 659 cc I4 , Minica Toppo
If your 2008-2013 Mitsubishi Toppo HID
Xenon Headlight low beam or Headlamp projector housing high
beam have problems, like light failed failure, flicker ,
bad , dipped beam very dim dimmer, dimming , got wet , getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , beam pattern problems
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , color inconsistency , color
temperature , go up and down , moving up and donw , pointing
down , overheating , distance control defective , leveling
malfuncation ,turning pink , condensation , not turning
off , gone ping , turned purple ,turned pink , trasig ,
not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|