2003-2009 Genuine Original Factory Fit OEM Nissan 350Z Also Called : Nissan Fairlady Z Z33 Headlights LHD RHD Headlamp HID D2S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , D2S D2R Philips Xenon Gas Bulb Globes , Wires Cable Plug , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front

Nissan 350Z (Z33) : 2-door hatchback coupé , 2-door roadster

3.5 L VQ35DE V6
3.5 L VQ35HR V6

Fairlady Z Type E , 350Z 35th Anniversary Edition , Nismo R-Tune , S-Tune GT , 380RS , Nismo Type 380RS-Competition , Grand Am , JGTC/Super GT , Super Taikyu , NASA , SCCA

If your 2003-2009 Nissan 350Z OEM Xenon HID Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your xenon led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.


Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.