1999-2008 Genuine Original Factory Fit OEM
Nissan Wingroad AD Y11 Series Also Called : Nissan Pulsar
Wagon (New Zealand) , Nissan Wingroad , Mazda Familia Wagon/Van
, Subaru Leone (1994-2001) Headlights LHD RHD Headlamp HID
Discharge D2R Ballast (Xenon Light Control Unit / Module
/ Controller / ECU / Computer / Starter / Electronic Unit
/ Steuergerät / Inverter ) , D2R Xenon Bulb Globes Lamp,
Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Nissan Wingroad AD
Y11 : 5-door van/wagon
1295 cc QG13DE I4 (Y11)
1497 cc QG15DE I4 (FY11)
1769 cc QG18DE/DEN I4 (HY11)
1998 cc SR20VE I4 (PY11 Wingroad)
1998 cc QR20DE I4 (RY11 Wingroad)
2184 cc YD22DD diesel I4 (EY11)
Aero Sport Limited , Wingroad Rider
If your 1999-2008 Nissan Wingroad AD Y11
Origianl HID Xenon Headlight low beam or Headlamp projector
housing high beam have problems, like light failed failure,
flicker , bad , dipped beam very dim dimmer, dimming , got
wet , getting dimmer, not working, flickering blinking ,
goes one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|