1997-2002 Genuine Original Factory Fit OEM
Nissan Elgrand E50 Mk1 Also Called : Isuzu Fargo Filly ,
Isuzu Filly , Isuzu Super Medic II , Nissan Caravan Elgrand
, Nissan Homy Elgrand , Nissan Paramedic Headlights LHD
RHD Headlamp HID Discharge D2R D2S Ballast (Xenon Light
Control Unit / Module / Controller / ECU / Computer / Starter
/ Electronic Unit / Steuergerät / Inverter ) , D2S D2R Xenon
Bulb Globes Lamp , Wires Cable , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(First generation)
Nissan Elgrand E50
: 4-door minivan , 4-door van (commercial models)
3.3 L VG33E V6
3.5 L VQ35DE V6
3.0 L ZD30DDTi I4 diesel turbo
3.2 L QD32ETi I4 diesel turbo
KOITO 100-24777
Nissan Paramedic and Isuzu Super Medic II , Elgrand Jumbo
Taxi
If your 1997-2002 Nissan Elgrand E50 Mk1
OEM Xenon HID Headlight low beam or Headlamp projector housing
high beam have problems, like light failed failure, flicker
, bad , dipped beam very dim dimmer, dimming , got wet ,
getting dimmer, not working, flickering blinking , goes
one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|