2003-2009 Genuine Original Factory Fit OEM
Nissan Teana J31 Mk1 Gen1 Also Called : Nissan Maxima ,
Nissan Cefiro , Renault Samsung SM7/SM5 , Renault Safrane
JDM HID Xenon Projector Headlights LHD RHD Headlamp D2S
Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) , D2S Philips Xenon Bulb , Projector Reflector
Blow , Plastic Lens Cover Foggy , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(First generation)
Nissan Teana J31
: 4-door sedan
Petrol:
2.0 L QR20DE I4
2.3 L VQ23DE V6
3.5 L VQ35DE V6
200JK , 230JM , 230JK
, 350JM , 200XL , 250XV , 350XV
If your 2003-2009 Nissan Teana J31 Origianl
HID Bi-Xenon Headlight low beam or Headlamp projector housing
high beam have problems, like light failed failure, flicker
, bad , dipped beam very dim dimmer, dimming , got wet ,
getting dimmer, not working, flickering blinking , goes
one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|