2013-2021 Genuine Original
Factory Fit OEM Peugeot 308 II T9 Mk2 OEM Full LED Projector
Headlights LHD RHD Headlamp Ballast (LED Light Control Unit
/ Module / Controller / ECU / Computer / Starter / Electronic
Unit / Steuergerät / Inverter) , Wires Calbe, Projector
Reflector Bowl , Leveling Motor Control Module , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Second generation)
Peugeot 308 T9 Gen2
: 5-door hatchback , 5-door estate , 4-door saloon
Petrol:
1.2 L VTi I3
1.2 L PureTech I3
1.6 L Prince turbo I4
Diesel:
1.5 L DV5 RC 16V I4
1.6 L DV6 C/D/FC 8V I4
2.0 L DW10 FC/FD I4
GT , GTI , SW , TRC , Peugeot Sport
If your 2013-2021 Peugeot 308 Mk2 T9 OEM
Full LED Headlight low beam or Headlamp projector housing
high beam have problems, like light failed failure, flicker
, bad , dipped beam very dim dimmer, dimming , got wet ,
getting dimmer, not working, flickering blinking , goes
one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit led control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|