2017-2019 Genuine Original Factory Fit OEM Porsche 991 911 Carrera Full LED Dual Projector Headlights LHD RHD Headlamp Ballast ( Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , Inside LED Projector Reflector , Wires Cable Harness , LED Cooling Fan , LED DRL Turn Signal Corner Module , Plastic Lens Cover , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Second phase Generation)

Porsche 991 911 Carrera : 2-door coupé , 2-door Targa top , 2-door convertible , 2-door speedster

3.0 L twin-turbocharged Flat-6
3.4 L Flat-6
3.8 L Flat-6
3.8 L twin-turbocharged Flat-6
4.0 L Flat-6

911 Carrera and Carrera S , 911 Carrera T , 911 Targa 4 and 4S , 911 Carrera/Targa 4 GTS , 911 GT3 and GT3 Touring Package , 911 GT3 GT2 RS , 911 Turbo, Turbo S and Turbo S Exclusive Series , 935 , 911 Speedster

If your 2017-2019 Porsche 991.2 911 Carrera Original Full LED Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your xenon led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit led control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.