2012-2015 Genuine Original Factory Range Rover Evoque L538 HID Bi-Xenon Headlights LHD RHD Headlamp Assembly D3S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät /Inverter ) , D3S Osram Discharge Bulb Globes , Bulb Ring Holder , Projector Reflector , Plastic Lens Cover , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front(First generation)

Range Rover Evoque Gen1 : 3-door SUV , 5-door SUV

Petrol:
2.0 L Ford EcoBoost turbo I4
2.0 L Ingenium turbo I4
Diesel:
2.0 L Ingenium turbo I4
2.2 L Ford Duratorq turbo I4

If your 2012-2015 Range Rover Evoque HID Bi-Xenon L538 Headlight low beam or Headlamp high beam have problems, like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enoug h , flashing . warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original led parts like: ballast, led bulb, control unit module , reflector , igniter , or wire harness cable to repair and fix your LED headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.