2013-2017 Genuine Original Factory Land Rover Range Rover HSE Vogue Bi-HID PES Projector Xenon AFS Adaptive Headlights LHD RHD Headlamp Assembly D3S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter /Sation / Electronic Unit / Steuergerät /Inverter ) , D3S Philips Discharge Globes , Plastic Lens Cover , LED Daytime Running Lights DRL Module , Wires Cable Harness , Projector Reflector , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Fourth generation)

Range Rover HSE Vogue: 5-door 4x4 / SUV

Petrol
2.0 L Ingenium PHEV I4
3.0 L AJ126 s/c V6
3.0 L Ingenium MHEV I6
5.0 L AJ133 V8
5.0 L AJ133 s/c V8
Diesel
3.0 L TDV6/SDV6 V6
3.0 L SDV6 Hybrid V6
4.4 L Ford SDV8 V8

If your 2013-2017 Land Rover Range Rover HSE Vogue HID Bi-Xenon DRL Headlight low beam or Headlamp high beam have problems, like light failed failure, flicker , dipped beam very dim dimmer, getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , go up and down , moving up and donw , pointing down , distance control defective , malfuncation ,turning pink , not turning off , gone ping , turned purple ,turned pink , not bright enoug h , flashing . warning light ,not working properly , keeps burning out , have any other fault issues, you only need to change or replace related original led parts like: ballast, led bulb, control unit module , reflector , igniter , or wire harness cable to repair and fix your LED Xenon headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.