2020-2024 Genuine Original Factory Fit OEM Skoda Enyaq RS iV Full LED Projector Headlights LHD RHD Headlamp Assembly Ballast (LED Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , Projector Reflektor Bowls, Plastic Lens Cover Protector , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front

Škoda Enyaq : 5-door SUV , 5-door coupé SUV (Enyaq Coupe)

Electric motor Permanent Magnet Synchronous Motor on Rear Axle
50: 109 kW (146 hp)[1]
60: 132 kW (177 hp)[1]
80: 150 kW (200 hp)[1]
85: 210 kW (280 hp)[2]
Asynchronous motors (ASMs) on Front Axle and Permanent Magnet Synchronous Motor on Rear Axle
80X: 195 kW (261 hp)[1]
85X: 210 kW (280 hp)[2]
RS (2021-2023): 225 kW (302 hp)[3][1]
RS (2024-): 250 kW (340 hp)[3][2]
Battery
80, 85, 80X and RS: 82 (77 usable) kWh lithium-ion,[3]
liquid-cooled[4][1]
60: 62 (58 usable) kWh lithium-ion[1]
50: 55 (52 usable) kWh lithium-ion[1]
Enyaq RS iV , Enyaq Coupe RS iV

If your 2020-2024 Skoda Enyaq iV Full LED Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your xenon led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit led control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.