2017-2020 Genuine
Original Factory Fit OEM Skoda Kodiaq NS7 NV7 NS6 Full LED
Matrix Headlights LHD RHD Headlamp Assembly Ballast (Xenon
Light Control Unit / Module / Controller / ECU / Computer
/ Starter / Electronic Unit / Steuergerät / Inverter ) ,
Wires Cable Harness , Bulb Holder Ring Clipe Adapter, Projector
Reflektor Bowls, Plastic Lens Cover , Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(First generation)
Škoda Kodiaq Gen1
: 5-door SUV
Petrol:
1.4 L TSI 125 I4
1.4 L TSI 150 I4
2.0 L TSI 180 I4
2.0 L TSI 220 I4 (Kodiaq GT, China)
2.0 L TSI 245 I4 (Kodiaq vRS Facelift)
Diesel:
2.0 L TDI 150 I4
2.0 L TDI 190 I4
2.0 L TDI 200 I4 (2020-)
2.0 L TDI 240 I4 (Kodiaq vRS)
If your 2017-2020 Skoda Kodiaq Full LED
Matrix Headlight low beam or Headlamp projector housing
high beam have problems, like light failed failure, flicker
, bad , dipped beam very dim dimmer, dimming , got wet ,
getting dimmer, not working, flickering blinking , goes
one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit led control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|