2016-2019 Genuine
Original Factory Fit OEM Skoda Superb B8 3V HID Bi-Xenon
Headlights Headlamp D3S Ballast (Xenon Light Control Unit
/ Module / Controller / ECU / Computer / Starter / Electronic
Unit / Steuergerät / Inverter ) , D3S Xenon Bulb Globes
, Wires Cable Harness , Bulb Holder Ring Clipe Adapter,
Projector Reflektor Bowls, Plastic Lens Cover , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front(Third generation)
Škoda Superb B8 3V
: 5-door liftback , 5-door estate
Engine
Petrol:
1.4 L CZDA, CZEA I4 turbo (2015–2018) (Regular)
1.5 L DADA, DPCA I4 turbo (2018–2021)
1.8 L CJSA, CJSC I4 turbo (2015–2018)
2.0 L CHHB, DKZA I4 turbo
Petrol PHEV:
1.4 L DGEB I4 turbo (iV PHEV)
Diesel:
1.6 L DCXA, DCZA I4 turbo (diesel; 2015–2020)
2.0 L CRLB, DFEA, DDAA, DFCA, DFHA, DTUA I4 turbo
Electric motor 85 kW (116 PS; 114 hp) Permanent magnet AC
synchronous motor
If your 2016-2019 Skoda Superb B8 3V HID
Bi-Xenon AFS Headlight low beam or Headlamp projector housing
high beam have problems, like light failed failure, flicker
, bad , dipped beam very dim dimmer, dimming , got wet ,
getting dimmer, not working, flickering blinking , goes
one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|