2009-2013 Genuine Original Factory Fit OEM Subaru Forester Mk3 SH JDM STI HID Xenon Headlights LHD RHD Headlamp D2S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , D2R Xenon Bulb Globes , Igniter Scoket , Plastic Lens Cover , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Third Generation)

Subaru Forester SH Gen3 : 5-door SUV

Gasoline:
2.0 L EJ20 H4
2.0 L EJ20 H4 turbo
2.0 L FB20 H4
2.5 L EJ25 H4
2.5 L FB25 H4
2.5 L EJ25 H4 turbo
Diesel:
2.0 L EE20 H4 turbo
X , XS , XS Premium , 2.0 Diesel , 2.0 Premium Diesel , XT , XT Premium , S-Edition ,

If your 2009-2013 Subaru Forester SH Mk3 STI HID Xenon Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your xenon led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.