2003-2010 Genuine Original
Factory Fit OEM Subaru R2 HID Xenon Headlights Headlamp
D2S D2R Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) , D2S Philips Xenon Bulb, Igniter Cable , Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (Fourth Generation GP GJ)
Subaru R2 : 658cc
EN07U I 4 , 658cc EN07D DOHC AVCS I 4 , 658cc EN07X DOHC
I 4 supercharged (STi) , R2 STi
If your 2003-2010 Subaru R2 HID Xenon headlight have
problems like: light failed failure, very dim dimmer, dipped
, waring light , dipped beam, keeps going out , not working,
flickering , error , fault , goes on and off out , go up
and down , moving up and donw , pointing down , distance
control defective , malfuncation ,turning pink , not turning
off , gone ping , turned purple ,turned pink , not bright
enoug h , flashing . warning light ,not working properly
, keeps burning out , or have any other issues, you only
need to change or replacement original xenon parts like:
ballast, gas discharge bulb, igniter or wire harness, cable
to repair your HID headlamp is ok, no need to cost a lot
of money to buy high price a whole brand new headlight assembly
like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|