2015-2021 Genuine Original
Factory Fit OEM Subaru WRX STI VA Mk1 JDM Full Dual LED
Projector Adaptive Headlights LHD RHD Headlamp Ballast (LED
Light Control Unit / Module / Controller / ECU / Computer
/ Starter / Electronic Unit / Steuergerät / Inverter ) ,
Assembly Plastic Lens Cover , Projector Reflector Bowl ,
Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (First Generation)
Subaru WRX STI VA
Gen1 : 4-door sedan (standalone models)
Petrol:
2.0 L EJ207 H4-T (STI, Japan only)
2.0 L FA20F H4-T (WRX)
2.5 L EJ257 H4-T (STI, export)
WRX STI Launch Edition , Hyper Blue , Diamond Edition ,
WRX 50th Anniversary Edition , WRX STI Type RA , WRX STI
RA-R , WRX Raiu Edition , WRX Series.Gray , WRX STI TC380
, Kanrai Edition , EJ20 Final Edition , VMG VM4 LEVORG
If your 2015-2021 Subaru WRX STI JDM Bi-LED
Headlight low beam or Headlamp projector housing high beam
have problems, like light failed failure, flicker , bad
, dipped beam very dim dimmer, dimming , got wet , getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , beam pattern problems
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , color inconsistency , color
temperature , go up and down , moving up and donw , pointing
down , overheating , distance control defective , leveling
malfuncation ,turning pink , condensation , not turning
off , gone ping , turned purple ,turned pink , trasig ,
not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your xenon led headlamps is ok,
no need to cost a lot of money to buy a whole brand new
headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit LED control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|