2012-2017 Genuine Original
Factory Fit OEM Toyota Camry Also Called : Daihatsu Altis
, Toyota Aurion JDM HID Xenon Headlights LHD RHD Headlamp
D4S Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) ,D4S Xenon Bulb Globes , Wires Cable Harness
, Projector Reflektor Bowls, Headlight Lens Cover Replacement
Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front
Toyota Camry Aurion
XV50 : 4-door Sedan
Engine
2.0 L 1AZ-FE I4 145 hp
2.0 L 6AR-FSE I4 VVTi-W 165 hp (Malaysia,Thailand,Taiwan,Russia
and China)
2.5 L 2AR-FE I4 178–181 hp
2.5 L 5AR-FE I4 173 hp (China)
3.5 L 2GR-FE V6 268 hp
2.5 L 2AR-FXE I4 154 hp Hybrid electric
Electric motor 105 kW (141 hp; 143 PS) 2JM permanent magnet
synchronous (hybrid)
If your 2012-2017 Toyota Aurion Camry Altise
Headlight low beam or Headlamp projector housing high beam
have problems, like light failed failure, flicker , bad
, dipped beam very dim dimmer, dimming , got wet , getting
dimmer, not working, flickering blinking , goes one and
off , keeps going out , flashlight , beam pattern problems
, making noise , not bright enough , not focused , stopped
working , turning yellow and the dashboard displayer have
warning light , error code , color inconsistency , color
temperature , go up and down , moving up and donw , pointing
down , overheating , distance control defective , leveling
malfuncation ,turning pink , condensation , not turning
off , gone ping , turned purple ,turned pink , trasig ,
not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your led headlamps is ok, no need
to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|