2018-2022 Genuine Original Factory Fit OEM Toyota Crown S220 Mk15 Full LED Projector Headlights LHD RHD Headlamp Ballast (LED Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , Plastic Lens Cover , Projector Reflecto Bowl , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Fifteenth Generation)

Toyota Crown S220 Gen15 : 4-door sedan

Engine
Gasoline:
2.0 L 8AR-FTS turbo I4
Gasoline hybrid:
2.5 L A25A-FXS I4
3.5 L 8GR-FXS V6
Electric motor
105 kW (141 hp; 143 PS) 1KM AC synchronous (2.5 L hybrid)
132 kW (177 hp; 179 PS) 2NM AC synchronous (3.5 L hybrid)
AZSH21 , AZSH20 , ARS220 , GWS224

If your 2018-2022 Toyota Crown S220 LED Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit LED control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.