2003-2008 Genuine Original
Factory Fit OEM Toyota Harrier XU10 XU30 Also Called : Lexus
RX300 RX330 RX350 HID Xenon Headlights Headlamp D2S D2R
Ballast (Xenon Light Control Unit / Module / Controller
/ ECU / Computer / Starter / Electronic Unit / Steuergerät
/ Inverter ) , D2S D2R Philips Xenon Bulb, Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (First Second Generation)
Toyota Harrier XU10
XU30 : 5-door wagon , 2.2 L 5S-FE I4 , 2.4 L 2AZ-FE I4 ,
3.0 L 1MZ-FE V6 , 3.3 L 3MZ-FE V6 , 3.5 L 2GR-FE V6
If your 2003-2008 Toyota Harrier XU10 XU3 HID Xenon
headlight have problems like: light failed failure, very
dim dimmer, dipped , waring light , dipped beam, keeps going
out , not working, flickering , error , fault , goes on
and off out , go up and down , moving up and donw , pointing
down , distance control defective , malfuncation ,turning
pink , not turning off , gone ping , turned purple ,turned
pink , not bright enoug h , flashing . warning light ,not
working properly , keeps burning out , or have any other
issues, you only need to change or replacement original
xenon parts like: ballast, gas discharge bulb, igniter or
wire harness, cable to repair your HID headlamp is ok, no
need to cost a lot of money to buy high price a whole brand
new headlight assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|