2020-2025 Genuine Original Factory Fit OEM Toyota Venza XU80 Mk2 Also Called : Toyota Harrier Full LED Projector Headlights LHD RHD Headlamp Ballast (LED Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , Plastic Lens Cover , Projector Reflecto Bowl , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Second generation)

Toyota Venza XU80 Gen2 : 5-door SUV

Engine
Petrol:
1986 cc M20A-FKS I4 (MXUA80/85)
1986 cc M20D-FKS I4 (China)
Petrol hybrid:
2487 cc A25A-FXS I4 (AXUH80/85)
2487 cc A25F-FXS I4 (China)
Petrol plug-in hybrid:
2487 cc A25A-FXS I4 (AXUP80/85)
Electric motor
88 kW (118 hp; 120 PS) 3NM synchronous (front, hybrid)
40 kW (54 hp; 54 PS) 4NM synchronous (rear, hybrid)
134 kW (180 hp; 182 PS) 5NM + 40 kW (54 hp; 54 PS) 4NM (plug-in hybrid)
MXUA80 , MXUA85

If your 2020-2025 Toyota Venza Harrier XU80 Mk2 LED Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit LED control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.