2010-2021 Genuine Original Factory Fit OEM Volkswagen VW Amarok Mk1 2H HID Bi-Xenon Headlights LHD RHD Headlamp D3S Ballast (Xenon Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , D3S Xenon Bulb Globes , Wires Cable Harness , LED DRL Driver Module , Projector Reflektor Bowls, Plastic Lens Cover , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (First generation)

Volkswagen Amarok : 2-door single cab , 4-door double cab , Pickup

2.0 L I4 TSI (petrol)
2.0 L I4 TDI CR 03L (diesel)
2.0 L I4 BiTDI CR (diesel)
3.0 L V6 TDI CR (diesel)
S6B S7A S7B
Highline , Core V6 Low-Range , Variants , XL +31 CM XXL , Amarok Sochi Special Edition , Amarok Polar Expedition

If your 2010-2021 Volkswagen VW Amarok Mk1 Bi-Xenon Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit xenon control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.