2010-2015 Genuine Original
Factory Fit OEM Volkswagen VW Golf Mk6 VI HID Bi-Xenon Headlights
Headlamp D1S Ballast (Xenon Light Control Unit / Module
/ Controller / ECU / Computer / Starter / Electronic Unit
/ Steuergerät / Inverter ) , D1S Xenon Bulb Globes Lamp
Retaining Ring Holder Clip Retainer , Wires Cable Harness
, Projector Reflektor Bowls , Plastic Lens Cover , AFS LED
DRL Module Replacement Sale
Part will fit : Driver side / Passenger
side / Left / Light / Front (Sixth generation)
Volkswagen Golf Mk6
(A6/Typ 5K) : 3-door hatchback , 5-door hatchback , 5-door
estate/wagon , 2 door cabriolet
Petrol:
1.2 L TSI I4
1.4 L I4
1.4 L t/c and s/c TSI I4
1.6 L I4
1.8 L TSI I4
2.0 L TSI I4
2.5 L I5
Diesel:
1.6 L TDI I4 CR
2.0 L TDI I4 CR
Variant , Twin Drive
, 77TSI , 118TSI Comfortline , Golf R , GTI Edition 35 ,
GTI
If your 2010-2015 Volkswagen VW Golf Mk6
HID Bi-Xenon Headlight low beam or Headlamp projector housing
high beam have problems, like light failed failure, flicker
, bad , dipped beam very dim dimmer, dimming , got wet ,
getting dimmer, not working, flickering blinking , goes
one and off , keeps going out , flashlight , beam pattern
problems , making noise , not bright enough , not focused
, stopped working , turning yellow and the dashboard displayer
have warning light , error code , color inconsistency ,
color temperature , go up and down , moving up and donw
, pointing down , overheating , distance control defective
, leveling malfuncation ,turning pink , condensation , not
turning off , gone ping , turned purple ,turned pink , trasig
, not bright enough , flashing . warning light ,not working
properly , adaptive function failure , keeps burning out
, retrofitting challenges , have any other fault issues,
troubleshooting , you only need to change or replace related
original led xenon parts like: repair tips , transformer
ballast, xenon bulb, control unit driver module , reflector
, glare shield , waterproof , igniter , or wiring wire harness
cable to repair and fix your led headlamps is ok, no need
to cost a lot of money to buy a whole brand new headlight
assembly like the car dealer suggest.
Normally speaking, when your headlight have problem, check
out the fuse first, if it’s ok, then replace the factory
fit xenon control unit box ballast is ok, because from our
many years experience, when the headlight not work, 90%
of the problem is on the ballast.
|