2020-2025 Genuine Original Factory Fit OEM Volvo XC90 Mk2 Facelift Full LED Adaptive Headlights LHD RHD Headlamp ( LED Light Control Unit / Module / Controller / ECU / Computer / Starter / Electronic Unit / Steuergerät / Inverter ) , Projector Reflector Bowl , Wires Cable Harness, AFS DRL Driver Module , Plastic Lens Cover Protector , Replacement Sale

Part will fit : Driver side / Passenger side / Left / Light / Front (Second Generation Refresh)

Volvo XC90 : 5-door 2-3 row SUV

Engine
Petrol:
2.0 L Drive-E turbo I4
2.0 L Drive-E twincharged I4
2.0 L B4204T27 Drive-E twincharged mild hybrid I4
2.0 L Drive-E twincharged PHEV I4
Diesel:
2.0 L Drive-E turbo I4
2.0 L D420T2 Drive-E turbodiesel mild hybrid I4
Electric motor
14 hp (10 kW; 14 bhp) B-ISG (B5/B6 MHEV)
Permanent Magnet Synchronous Motors (T8 Twin Engine/T8 Recharge)
Momentum, R Design, and Inscription

XC90 T8 Excellence , D4 , D5 , T6 , B5 , B6 , T5 , AWD

If your 2020-2025 Volvo XC90 Full LED System Headlight low beam or Headlamp projector housing high beam have problems, like light failed failure, flicker , bad , dipped beam very dim dimmer, dimming , got wet , getting dimmer, not working, flickering blinking , goes one and off , keeps going out , flashlight , beam pattern problems , making noise , not bright enough , not focused , stopped working , turning yellow and the dashboard displayer have warning light , error code , color inconsistency , color temperature , go up and down , moving up and donw , pointing down , overheating , distance control defective , leveling malfuncation ,turning pink , condensation , not turning off , gone ping , turned purple ,turned pink , trasig , not bright enough , flashing . warning light ,not working properly , adaptive function failure , keeps burning out , retrofitting challenges , have any other fault issues, troubleshooting , you only need to change or replace related original led xenon parts like: repair tips , transformer ballast, xenon bulb, control unit driver module , reflector , glare shield , waterproof , igniter , or wiring wire harness cable to repair and fix your led headlamps is ok, no need to cost a lot of money to buy a whole brand new headlight assembly like the car dealer suggest.

Normally speaking, when your headlight have problem, check out the fuse first, if it’s ok, then replace the factory fit LED control unit box ballast is ok, because from our many years experience, when the headlight not work, 90% of the problem is on the ballast.